Thinner

  To maximize the flux capability, select a suitable thinner to lower the solid content of the flux of the flux of reinforce thevaporized solvent.

     Cleaner

  Our cleaners(solvents used to clean the flux residue) have little degrading effect on the ozone layer. They are used to clean rosin or resin residue, oil or fat stains. They are suitable to assist the steam cleaning process for a completely degreasing operation or wherever low cost cleaning process is desired. with sufficient solvent, both soakingg in and spraying on methods can be applid. The advantages of low boiling point and little uncomfortable odor make it possibleto use them repeatedly.

     Application of the cleaner

  They are suitable for brush cleaning or machin cleaning, especialy for ultrasonic cleaning in which they are most effective;

Can be used under room temperature or proper higher temperature;

The cleaning time is dependent on the actual conditions;

Due to a medium evaporation speed, usually it will take tens of seconds to 2 minuties to dry off the PCB after cleaning;

The cleaning ability will degrade after repeating application, pay attention to replace the cleaner in time.

     Anti-oxdation oil

Add this product into the molten solder pot for wave soldering, it can make the solder anti-oxidation and reduce the dross dramatically.